LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1995 >> 3000GT SL, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - Tests W/Codes - OBD-I (3.0L) >> Diagnostic Tests >> Code 61: Transaxle Control Module Signal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Code 61: Transaxle Control Module Signal

NOTE: For component terminal identification, see TERMINAL IDENTIFICATION  in this article. For appropriate WIRING DIAGRAMS, see WIRING DIAGRAMS  section.
  1. Disconnect Transaxle Control Module (TCM) and PCM connectors. Ground TCM connector terminal No. 7. Using DVOM, check continuity between chassis ground and PCM connector terminal No. 116. If continuity does not exist, repair wiring harness as necessary. If continuity exists, go to next step.
  2. Ground TCM connector terminal No. 9. Check continuity between chassis ground and PCM connector terminal No. 59. If continuity does not exist, repair wiring harness as necessary. If continuity exists, go to next step.
  3. Ground TCM connector terminal No. 108. Check continuity between chassis ground and PCM connector terminal No. 7. If continuity does not exist, repair wiring harness as necessary. If continuity exists, test is complete. Intermittent problem may exist. See TESTS W/O CODES - 3.0L article.
scientia non olet · About LEMON Manuals