LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1995 >> Eclipse RS, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.0L Non-Turbo >> Diagnostic Tests >> Code 101: Fuel Pump Relay Control Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 101: Fuel Pump Relay Control Circuit

NOTE: For component terminal identification, see TERMINAL IDENTIFICATION  in this article. For appropriate WIRING DIAGRAMS, see WIRING DIAGRAMS  section.
  1. Remove fuel pump relay. Measure resistance between relay terminals No. 4 and 6. Resistance should be 35-75 ohms. Replace fuel pump relay if continuity is not as specified.
  2. Connect 12-volt power source between relay terminals No. 4 and 6. Connect positive lead to terminal No. 6. With relay energized, continuity should exist between terminals No. 2 and 8. With power source removed, continuity should not exist. Replace MFI relay if any measurements are not as specified.
  3. Turn ignition on. Measure voltage between terminal No. 6 (Black/White wire) of fuel pump relay connector and ground. If battery voltage exits, check PCM connector and wiring harness between fuel pump relay connector and PCM. If wiring connector is okay, replace PCM. If battery voltage does not exist, check wiring harness and junction connectors between fuel pump relay connector and ignition switch.
scientia non olet · About LEMON Manuals