Interior Light Test 2B - Courtesy Light Inoperative With Any Door

WARNING: This page is about a different car, the 1995 Dodge Stratus and 1995 Chrysler Cirrus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform INTERIOR LIGHT TEST 2A before proceeding with this test. For connector terminal identification, see CONNECTOR IDENTIFICATION in BODY CONTROL COMPUTER INTRODUCTION. Perform TEST VER-1A after each repair.

CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.

Disconnect scan tool probe from junction block 6-pin connector. Turn ignition off. Disconnect BCM from junction block and ensure connector is clean and not damaged. Using scan tool in voltmeter mode, check voltage on junction block BCM connector terminal No. 9. If voltage is more than 10 volts, replace BCM. If voltage is less than 10 volts, replace junction block.