Test 118B - Washer Pump Problem

WARNING: This page is about a different car, the 1995 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS - 3.0L article in ENGINE PERFORMANCE. Perform TEST VER-1 after each repair.

Turn ignition off. Using scan tool in ohmmeter mode, check resistance of washer pump connector terminal No. 2 (Black wire). If resistance is more than 5 ohms, repair open in Black wire. If resistance is less than 5 ohms, replace washer pump motor.