Test 77A - Key-In Lamp On Constantly
WARNING: This page is about a different car, the 1995 Eagle Vision, 1995 Dodge Intrepid, 1995 Chrysler New Yorker, 1995 Chrysler LHS, and 1995 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see appropriate article in ENGINE PERFORMANCE:
- WIRING DIAGRAMS - 3.3L
- WIRING DIAGRAMS - 3.5L
- Perform TEST VER-1 after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
Turn ignition off. Disconnect Body Control Module (BCM) Bone connector. If key-in lamp goes off, replace BCM. If key-in lamp does not go off, repair short to ground in Yellow/Red wire.