Speed Control Menu

WARNING: This page is about a different car, the 1995 Eagle Vision, 1995 Dodge Intrepid, and 1995 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

To perform cruise control system tests using scan tool, scan tool must be in SPEED CONTROL MENU. At SPEED CONTROL MENU, trouble codes and scan tool test functions can be accessed. To reach SPEED CONTROL MENU, turn ignition off. Connect scan tool to data link connector. Connector is located under center of dash, right of steering column. Turn ignition switch to RUN position.
NOTE: DO NOT touch scan tool keypad during scan tool power-up sequence or an error message will result.
All scan tool character positions will glow and copyright information will appear on the display screen for a few seconds. If the scan tool screen is blank or any error messages appear, refer to the TESTS W/CODES - BODY CONTROL COMPUTER article in the ENGINE PERFORMANCE section.
After a few seconds scan tool menu will appear. At scan tool menu, press "4" (SELECT SYSTEM) key. Press ENTER key. At SELECT SYSTEM menu, press "1" (ENGINE) key. Press ENTER key. Scan tool menu will appear indicating engine year, size, type of transmission and PCM part number.
After a few seconds AIR COND menu will appear. Press "1" (WITH A/C) or press "2" (WITHOUT A/C). Scan tool display will change to ENGINE SYSTEMS menu. At ENGINE SYSTEMS menu, press "3" (SPEED CONTROL) key. Press ENTER key.
Display will change to SPEED CONTROL. At SPEED CONTROL MENU, specific test functions programmed into scan tool can be performed. Following scan tool modes can be accessed: SYSTEM TESTS, READ TROUBLE CODES, STATE DISPLAY, ACTUATOR TESTS and ADJUSTMENTS.