Brakelight Switch
WARNING: This page is about a different car, the 1995 Eagle Vision, 1995 Dodge Intrepid, and 1995 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect brakelight switch 6-pin connector. Using an ohmmeter, check for continuity at switch side of connector terminals. With brakelight switch depressed, continuity should exist between terminals No. 1 and 2, and between terminals No. 3 and 4. With brakelight switch released, continuity should exist between terminals No. 5 and 6. See Figure . If continuity is not as specified, check brakelight switch adjustment. If switch adjustment is okay, replace defective brakelight switch.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.