LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1998 >> Eclipse RS, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Controls - Adjustments >> Ignition Timing >> Ignition Timing >> All Other Models
April 5, 2026: LEMON Manuals is launched! Read the announcement.

All Other Models

  1. Ignition timing is controlled by Powertrain Control Module (PCM) and is not adjustable. Manufacturer provides procedure for checking timing. On models with distributor, DO NOT  attempt to adjust ignition timing by rotating distributor.
  2. Connect scan tool to Data Link Connector (DLC). DLC is located below dash, near steering column. See Figure. Install a timing light. Start engine and allow it to idle.
  3. Using scan tool, read curb idle speed (RPM). Ensure curb idle speed is about 750 RPM. Turn engine off. Curb idle speed is automatically controlled by Idle Air Control (IAC) system. If curb idle speed is not as specified, see DTC P0505 in appropriate TESTS W/CODES article.
    CAUTION: MFI system actuator test must be cancelled or test will continue to run for 27 minutes. Driving vehicle under this condition may damage engine.
  4. Using scan tool, select MFI SYSTEM ACTUATOR TEST, then select item 17 (BASIC IGNITION TIMING). Read basic ignition timing value. See IGNITION TIMING SPECIFICATIONS  table. If basic ignition timing is within specification, go to next step. If basic ignition timing is not within specification, cancel MFI system actuator test. See DTCS P0100 (except Mirage 1.5L), P0105, P0115 and P0335 in appropriate TESTS W/CODES article.
  5. Read actual ignition timing value. If actual ignition timing is not within specification, cancel MFI system actuator test. See DTCS P0100 (except Mirage 1.5L), P0105, P0115 and P0335 in appropriate TESTS W/CODES article.
scientia non olet · About LEMON Manuals