LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2000 >> Eclipse GS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Controls - Basic Diagnostic Procedures) >> Fuel System >> PGM-FI Main Relay >> 3.5RL
April 5, 2026: LEMON Manuals is launched! Read the announcement.

PGM-FI Main Relay: 3.5RL

WARNING: This page is about a different car, the 2000 Acura Integra, 2000 Acura 3.5RL, and 2000 Acura 3.2TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove PGM-FI main relay located under left side of instrument panel. Connect battery voltage to relayconnector "B" terminal No. 3 (Blue/Red wire). Connect connector "B" terminal No. 2 (Yellow/Green wire) to ground. See Figure.
  2. Test for continuity between relay connector "B" terminal No. 5 (Red/White wire) and connector "A" terminal No. 2 (Yellow wire). If continuity exists, go to next step. If continuity does not exist, replace relay.
  3. Connect battery voltage to relay connector "A" terminal No. 4 (Black/Yellow wire). Connect connector "B" terminal No. 7 (Black wire) to ground. Test for continuity between relay connector "A" terminals No. 1 and 3 (both Yellow/Black wires). If continuity exists, go to next step. If continuity does not exist, replace relay.
  4. Connect battery voltage to relay connector "A" terminal No. 1 (Yellow/Black wire). Connect connector "B" terminal No. 2 (Yellow/Green wire) to ground. Test for continuity between relay connector "B" terminal No. 5 (Red/White wire) and connector "A" terminal No. 2 (Yellow wire). If continuity exists, relay is okay. If continuity does not exist, replace relay.
scientia non olet · About LEMON Manuals