Cruise Control Switch Test
WARNING: This page is about a different car, the 2001 Mitsubishi Eclipse. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect cruise control switch harness connector. Check continuity or resistance between switch terminals. See CRUISE CONTROL SWITCH TEST table. Replace as necessary.
CRUISE CONTROL SWITCH TEST
| Switch Position | Condition | |
|---|---|---|
| OFF | Less Than 2 Ohms | |
| CANCEL | ||
| Between Terminals No. 1 & 3 | About 3900 Ohms | |
| Between Terminals No. 2 & 3 | About Zero Ohms | |
| RESUME | ||
| Between Terminals No. 1 & 3 | About 4800 Ohms | |
| Between Terminals No. 2 & 3 | About 910 Ohms | |
| SET | ||
| Between Terminals No. 1 & 3 | About 4100 Ohms | |
| Between Terminals No. 2 & 3 | About 220 Ohms | |
| ON | ||
| Between Terminals No. 1 & 2 | About 3900 Ohms | |