Specifications Index
GALANT SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | 145-188 ft. lbs. (196-255 N.m) | ||
| Battery | N/A | ||
| Brakes | |||
| Bleeding Sequence | |||
| With ABS | See BRAKE LINE BLEEDING SEQUENCE table under BLEEDING BRAKE SYSTEM . | ||
| Without ABS | See BRAKE LINE BLEEDING SEQUENCE table under BLEEDING PROCEDURES . | ||
| Disc & Drum Brakes | DISC & DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | See GENERATOR MINIMUM OUTPUT SPECIFICATIONS table under GENERATOR OUTPUT TEST . | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 11-15 psi | ||
| Thermostat R & I | N/A | ||
| Water Pump R & I | |||
| 2.4L | WATER PUMP | ||
| 3.0L | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | |||
| 2.4L | Oil pressure should be at least 11.4 psi (.80 kg/cm2 ) at curb idle. | ||
| 3.0L | Oil pressure should be at least 11 psi (.8 kg/cm2 ) at idle with engine oil temperature at 167-194°F (75-90°C). | ||
| Overhaul | |||
| 2.4L | ENGINE SPECIFICATIONS | ||
| 3.0L | ENGINE SPECIFICATIONS | ||
| Torque | |||
| 2.4L | TORQUE SPECIFICATIONS | ||
| 3.0L | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flexplate Torque | |||
| 2.4L | 100 ft. lbs. (135 N.m) | ||
| 3.0L | 55 ft. lbs. (75 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | N/A | ||
| Fuel Pressure Specification | FUEL PUMP | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| Fuel Pressure Release Procedure | RELIEVING FUEL PRESSURE | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER Wire routing may be included in Figure. | ||
| Spark Plugs | SPARK PLUGS | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Lug Nut Torque | 65-80 ft. lbs. (88-108 N.m) | ||