Specifications Index
MONTERO & MONTERO SPORT SPECIFICATIONS INDEX
| System | Specification/Procedure | |||
|---|---|---|---|---|
| Air Conditioning | ||||
| Service | SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Axle Nut/Hub Nut | N/A | |||
| Battery | N/A | |||
| Brakes | ||||
| Bleeding Sequence | ||||
| With ABS | ||||
| Montero | See BRAKE LINE BLEEDING SEQUENCE table under BLEEDING BRAKE SYSTEM . | |||
| Montero Sport 2WD | See BRAKE LINE BLEEDING SEQUENCE table under BLEEDING BRAKE SYSTEM . | |||
| Montero Sport 4WD | See BRAKELINE BLEEDING SEQUENCE table under BLEEDING BRAKE SYSTEM . | |||
| Without ABS | See BRAKE LINE BLEEDING SEQUENCE table under BLEEDING PROCEDURES . | |||
| Disc & Drum Brakes | DISC & DRUM BRAKE SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Charging | ||||
| Generator | See GENERATOR MINIMUM OUTPUT SPECIFICATIONS table under GENERATOR OUTPUT TEST . | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Drive Belts | ||||
| Adjustment | BELT ADJUSTMENT | |||
| Belt Routing | DRIVE BELT ROUTING | |||
| Engine Cooling | ||||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | |||
| Radiator Cap Pressure | 11-15 psi | |||
| Thermostat R & I | N/A | |||
| Water Pump R & I | ||||
| 3.0L | WATER PUMP | |||
| 3.5L | WATER PUMP | |||
| Engine Mechanical | ||||
| Compression | ENGINE COMPRESSION | |||
| Oil Pressure | ||||
| 3.0L | Oil pressure should be at least 11 psi (.8 kg/cm2 ) at idle with engine oil temperature at 167-194°F (75-90°C). | |||
| 3.5L | Information is not available from manufacturer. | |||
| Overhaul | ||||
| 3.0L | ENGINE SPECIFICATIONS | |||
| 3.5L | ENGINE SPECIFICATIONS | |||
| Torque | ||||
| 3.0L | TORQUE SPECIFICATIONS | |||
| 3.5L | TORQUE SPECIFICATIONS | |||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |||
| Flywheel/Flexplate Torque | 55 ft. lbs. (75 N.m) | |||
| Fuel System | ||||
| Fuel Filter Location | N/A | |||
| Fuel Pressure Specification | FUEL PUMP | |||
| Fuel Pressure Test Procedure | FUEL PRESSURE | |||
| Fuel Pressure Release Procedure | RELIEVING FUEL PRESSURE | |||
| Ignition | ||||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | |||
| Ignition Wires (Routing) | FIRING ORDER Wire routing may be included in Figure. | |||
| Spark Plugs | SPARK PLUGS | |||
| Starting | ||||
| Starter | STARTER SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Wheel Alignment | ||||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Wheel & Tire | ||||
| Lug Nut Torque | ||||
| Montero | 72-87 ft. lbs. (98-118 N.m) | |||
| Montero Sport With Aluminum Wheel | 72-87 ft. lbs. (98-118 N.m) | |||
| Montero Sport With Steel Wheel | 87-101 ft. lbs. (118-137 N.m) | |||