Other Monitor
This monitor applies to DTCs not covered by the rest of the monitors. Following conditions must be met during the test:
- Engine coolant temperature must be 176°F (80°C) or more.
- Atmospheric temperature is 41°F (5°C) or more.
- On A/T, selector lever is in "D" range.
Monitor takes about 10 minutes to complete. To run monitor, use illustration. See Fig 1 . Perform steps as follows:
- Remove all test equipment from vehicle and install all components and connectors that were removed or disconnected during testing.
- After engine is completely warmed up, turn ignition off.
- Start engine and accelerate to 35-40 MPH.
- Drive for 5 minutes or more at 35-40 MPH. On M/T, use 5th gear.
- Return vehicle to shop and let idle. While engine is idling, A/C switch must be in OFF position, lights and accessories must be off, steering wheel must be straight ahead, and A/T must be in "P" range or M/T in neutral. After idling for 5 minutes, turn ignition off.