Specifications Index
MONTERO SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | 167-209 ft. lbs. (226-284 N.m) | ||
| Battery | N/A | ||
| Brakes | |||
| Bleeding Sequence | |||
| With ABS | For procedure, see BLEEDING HYDRAULIC BRAKE BOOSTER . Sequence is RR, LR, RF, LF. | ||
| Without ABS | See BRAKE LINE BLEEDING SEQUENCE table under BLEEDING BRAKE SYSTEM . | ||
| Disc & Drum Brakes | DISC & DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | See GENERATOR MINIMUM OUTPUT SPECIFICATIONS table under OUTPUT CURRENT TEST . | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 11-15 psi | ||
| Thermostat R & I | Included in INTAKE MANIFOLD AND FUEL PARTS illustrations. Installation is located at >> E << THERMOSTAT INSTALLATION . | ||
| Water Pump R & I | N/A | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | Oil pressure should be 11.6 psi (80 kPa) or more at curb idle with engine oil temperature at 167-194°F (75-90°C). | ||
| Overhaul | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flexplate Torque | 51-57 ft. lbs. (70-78 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | FUEL FILTER | ||
| Fuel Pressure Specification | FUEL PUMP | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| Fuel Pressure Release Procedure | RELIEVING FUEL PRESSURE | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER Wire routing may be included in Figure. | ||
| Spark Plugs | SPARK PLUGS | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Lug Nut Torque | 72-87 ft. lbs. (98-118 N.m) | ||