INSPECTION PROCEDURE 2: The system does not accept the remote controlled radio switch (RH) only.: Diagnosis

1. Remove the airbag module (Refer to AIR BAG RESTRAINT SYSTEMS article).
2. Check the continuity by operating the remote controlled radio switch (RH) in each position.
   Fig 1: Switch Position And Measurement Value Table

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
   Fig 2: Checking Continuity By Operating Remote Controlled Radio Switch (RH) In Each Position

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Q: Is the remote controlled radio switch normal? 

1. YES:  Go to Step 2.
2. NO:  Replace the remote controlled radio switch (RH).

Q: Is remote controlled radio switch (RH) connector C-97 and clock spring connector C-96 in good condition? 

1. YES:  Go to Step 3.
2. NO:  Repair or replace it. The remote controlled radio switch (RH) should work normally.
   Fig 3: Checking Switch (RH) Connector C-97 And Clock Spring Connector C-96 For Damage

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Q: Are the wiring harness between emote controlled radio switch connector C-97 (terminals 1 and 2) and clock spring connector C-96 (terminals 4 and 5) in good condition? 

1. YES:  No action to be taken.
2. NO:  Repair the wiring harness. The remote controlled radio switch (RH) should work normally.
   Fig 4: Checking Wiring Harness Between Remote Controlled Radio Switch Connector C-97 And Clock Spring Connector C-96

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.