LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer ES, Automatic >> Repair and Diagnosis (Single Page) >> Steering >> Manual Steering >> Steering - Except Evolution >> Steering Wheel And Shaft Assembly >> Removal And Installation >> Removal Service Points >> << B >> Steering Wheel And Airbag Module Assembly Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

<< B >> Steering Wheel And Airbag Module Assembly Removal

  1. By sliding section A of the clock spring connector shown in the illustration in the arrow direction, disconnect the connector.
    Fig 1: Disconnecting Clock Spring Connector
    G01896694Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Loosen the bolt completely. Then, remove the steering wheel and airbag module assembly.
    NOTE: Use a hexagonal bit socket or a hexagonal wrench having an effective length of 75 mm (3.0 inches) or more in the hexagonal section and the diameter of 8 mm (0.31 inches) or more.
    Fig 2: Removing Steering Wheel And Airbag Module Assembly
    G01896695Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals