LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer ES, Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> On-Vehicle Service - Except Evolution >> A/T Key Interlock And Shift Lock Mechanisms >> Removal And Installation >> Installation Service Points >> >> C << Key Interlock Cable (Selector Lever Side) Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

>> C << Key Interlock Cable (Selector Lever Side) Installation

  1. Shift the selector lever to the "P" position.
  2. Turn the ignition key to the "LOCK" (OFF) position.
  3. Slide the washer and spring toward the lock cam, insert the cable into the stand off bracket and release the spring.
  4. Lightly push the key interlock cable into the key interlock cable housing toward the arrow (A) direction until the cable movement stops and the cable end eye is aligned with the shaft on the lock cam. Tighten the locking nut. Snap the cable end eye onto the shaft of the lock cam.
    1. Tightening torque: 12+/-2 N.m (107+/-17 in-lb) 
    Fig 1: Installing Key Interlock Cable (Selector Lever Side)
    G01876060Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Check the operation of the selector lever. (Refer to SELECTOR LEVER OPERATION CHECK  .)
scientia non olet · About LEMON Manuals