Self-Diagnosis Procedure

WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF.
Connect CONSULT-II to data link connector.

Fig 1: Connecting CONSULT-II To Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Start engine.
Drive vehicle over 30 km/h (19 MPH) for at least one minute.
Stop vehicle with engine running and touch "START" on CONSULT-II screen.

Fig 2: Displaying CONSULT-II
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "ABS".

Fig 3: Displaying Diagnosis System Selection
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "SELF-DIAG RESULTS".
- The screen shows the detected malfunction and how many times the ignition switch has been turned since the malfunction.
Fig 4: Displaying Self-Diag Mode
Courtesy of NISSAN MOTOR CO., U.S.A.
Make the necessary repairs following the diagnostic procedures.
After the malfunctions are repaired, erase the self-diagnostic results stored in the control unit by touching "ERASE".
Check ABS warning lamp for deactivation after driving vehicle over 30 km/h (19 MPH) for at least one minute.

NOTE: "SELF-DIAG RESULTS" screen shows the detected malfunction and how many times the ignition switch has been turned since the malfunction.

Fig 5: Displaying Select Diag Results

Courtesy of NISSAN MOTOR CO., U.S.A.