LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Manual Transaxle Overhaul - Evolution) >> Input Shaft >> Disassembly And Assembly >> Assembly Service Points >> >> F << Synchronizer Sleeve Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

>> F << Synchronizer Sleeve Installation

WARNING: This page is about a different variant/trim than selected.
  1. Check the installation of the synchronizer sleeve, and install it onto the 3rd-4th speed synchronizer hub.
    Fig 1: Installing 3rd-4th speed synchronizer hub
    G01869800Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Install the synchronizer sleeve so that the areas with teeth that have raised tips (three areas total) are aligned with the areas on the synchronizer hub that have deep grooves between the teeth (three areas total).
Fig 2: Identifying Installation Direction Of Synchronizer Sleeve
G01869801Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig 3: Aligning Synchronizer Sleeve Teeth With Raised Tips To Synchronizer Hub Deep Grooves Between Teeth
G01869802Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals