LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Manual Transaxle Overhaul - Evolution) >> Transaxle >> Disassembly And Assembly >> Assembly Service Points >> >> G << Control Housing Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

>> G << Control Housing Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: Squeeze out the sealant uniformly, while making sure that it is not broken or excessively applied.
  1. Apply a 0.2 mm (0.08 inch) diameter bead of sealant (Mitsubishi Genuine Part number MD997740 or equivalent) to the illustrated position of the transaxle case.
    NOTE: Be sure to install the case quickly while the sealant is wet (within 15 minutes).
  2. Install the control housing to the transaxle case and tighten the bolts to specified torque.
    1. Tightening torque: 18 +/- 2 ft-lb)
    NOTE: After installation, keep the sealed area away from the oil for approximately one hour.
Fig 1: Applying Sealant To Control Housing
G01869783Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals