>>E<< 1ST-2ND Speed Synchronizer Hub Installation

1. Set the output shaft on the press support stand.
2. Check that the 1st-2nd speed synchronizer hub is in the correct installation direction, and put it on the output shaft.
3. Using special tools MD998812, MD998814, MD998824 and MD998364, press install the 1st-2nd speed synchronizer hub with the press.
4. Make sure that the outer synchronizer ring on the 1st speed gear side can rotate freely.

Fig 1: Identifying Installation Direction Of 1St-2Nd Speed Synchronizer Hub

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Installing 1St-2Nd Speed Synchronizer Hub

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.