LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer Evolution >> Repair and Diagnosis (Single Page) >> Transmission >> Manual Trans >> Manual Transaxle Overhaul - Evolution >> Transaxle >> Disassembly And Assembly >> Assembly Service Points >> >> E << Transaxle Case Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

>> E << Transaxle Case Installation

CAUTION: Squeeze out the sealant uniformly, while making sure that it is not broken or excessively applied.
  1. Apply a 2 mm (0.08 inch) diameter bead of sealant (Mitsubishi Genuine Part number MD997740 or equivalent) to the illustrated position of the transaxle case.
    NOTE: Be sure to install the transaxle case while the sealant is wet (within 15 minutes).
  2. Install the transaxle case.
  3. Tighten the transaxle case mounting bolts to the specified torque.
    Fig 1: Applying Sealant To Transaxle Case
    G01869781Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    1. Tightening torque: 44 +/- 5 N.m (32 +/- 3 ft-lb)
    NOTE: After installation, keep the sealed area away from the oil for approximately one hour.
scientia non olet · About LEMON Manuals