LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer Evolution >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P0101: Mass Airflow Sensor Circuit Range/Performance Problem >> DTC Confirmation Test "B" (Using CONSULT-II)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Test "B" (Using CONSULT-II)

WARNING: This page is about a different car, the 2002 Nissan Maxima and 2002 Infiniti I35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition on. Start engine and warm to normal operating temperature. If engine will not start, go to DIAGNOSTIC PROCEDURE  . If engine starts, go to next step.
  2. Select DATA MONITOR mode with CONSULT-II. Observe MAS A/F SE B1 voltage while increasing engine speed to 4000 RPM. There should be a linear voltage increase in response to engine speed increase. If voltage is as specified, go to next step. If voltage is not as specified, go to DIAGNOSTIC PROCEDURE  .
  3. Maintain the following conditions for at least 10 consecutive seconds:
    • ENG SPEED: more than 2000 RPM.
    • THRTL SEN 1: more than 3 volts.
    • THRTL SEN 2: more than 3 volts.
    • Driving location: drive vehicle uphill to increase engine load.
  4. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  . If 1st trip DTC is not detected, system is okay at this time.
scientia non olet · About LEMON Manuals