When The Transmitter Is Used After Connecting Scan Tool MB991502 To The Data Link Connector Or Grounding Data Link Connector Terminal No. 1

Fig 1: Connecting Scan Tool MB991502

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Enter the hazard answerback customize mode by observing one of the following steps. If the ETACS-ECU enters the customize mode, its tone alarm will sound once.
- Turn the ignition switch to LOCK (OFF) position.
- Turn off the hazard warning light switch.
- Connect Scan Tool MB991502 to the data link connector terminal No. 1.
- Close the driver's side door.
- Leave the windshield washer switch on for at least 10 seconds. Then the ETACS-ECU tone alarm will sound once.
If the transmitter LOCK switch is pushed consecutively twice (within 2 seconds), the ETACS-ECU tone alarm will sound, indicating that the hazard answerback function can be enabled or disabled when the doors are locked.
- Enable the hazard answerback function when the doors are locked: The ETACS-ECU tone alarm will sound once.
- Disable the hazard answerback function when the doors are locked: The ETACS-ECU tone alarm will sound twice.
If the transmitter UNLOCK switch is pushed consecutively twice (within 2 seconds), the ETACS-ECU tone alarm will sound, indicating that the hazard answerback function can be enabled or disabled when the doors are unlocked.
- Enable the hazard answerback function when the doors are locked: The ETACS-ECU tone alarm will sound once.
- Disable the hazard answerback function when the doors are locked: The ETACS-ECU tone alarm will sound twice.
Exit the hazard answerback customize mode by observing one of the following steps:
- Disconnect Scan Tool MB991502 from the data link connector, or disconnect data link connector terminal No. 1 from the ground.
- Turn the ignition switch to position other than LOCK (OFF), or remove the ignition key.
- Open the driver's side door.
- Any other warning tone alarm output occurs.