LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer LS >> Repair and Diagnosis >> Transmission >> Automatic Trans >> On-Vehicle Service - Except Evolution >> Transaxle Control >> Removal And Installation >> Installation Service Point >> >> C << Transaxle Control Cable (Transaxle Side) Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

>> C << Transaxle Control Cable (Transaxle Side) Installation

  1. Place the transaxle manual control lever in the "N" position.
  2. Place the selector lever in the "N" position.
  3. Place the cable stud into the manual control lever slot and install the nut loosely. Gently pull the transaxle control cable into the manual control lever slot until the cable is taut. Tighten the nut to the specified torque.
    1. Tightening torque: 12+/-2 N.m (107+/-17 in-lb) 
    Fig 1: Installing Transaxle Control Cable (Transaxle Side)
    G01876056Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals