Removal And Installation
WARNING: This page is about a different car, the 2004 Mitsubishi Eclipse. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- For vehicles with ABS, be careful when handling the projection at the tip of the speed sensor so as not to damage it by striking against other parts.
- The front hub assembly should not be disassembled. When removing the front hub assembly, the wheel bearing inner race may be left at the spindle side. In this case, always replace the front hub assembly, otherwise the hub will damage the oil seal, causing oil leaks or excessive play.
Post-installation Operation Press Dust Cover with a Finger to Check for Crack or Damage in Ball Joint Dust Cover.
Required Special Tools:
- MB990326: Preload Socket
- MB990767: End Yoke Holder
- MB990998: Front Hub Remover and Installer
- MB991897: Ball Joint Remover