Speedometer Check

Adjust the pressure of tires to the specified level (Refer to TIRE INFLATION PRESSURE CHECK ).

1. Set the vehicle onto a speedometer tester and use wheel chocks to hold to front wheels.
2. Set the vehicle onto a speedometer tester and use wheel chocks to hold the rear wheels.
   Fig 1: Identifying Wheel Chocks

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. To prevent the front wheel from moving from side to side, attach tension bars to the tie-down hook, and secure both ends to anchor plates.
4. To prevent the vehicle from moving, attach a chain or wire to the rear retraction hook, and make sure the end of the chain or wire is secured.
5. Check if the speedometer indicator range is within the standard values.
   Fig 2: Identifying Tension Bar And Anchor Plate

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

   Standard value: 

   Fig 3: Identifying Standard Value

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
6. If not to the standard value, inspect for proper tire size. If not correct, replace the tires with original size tires and retest. If correct, replace the speedometer.