Fastener Tightening Specifications
WARNING: This page is about a different car, the 2004 Mitsubishi Eclipse. However, it is still accessible from the selected car via links, so may be relevant.
FASTENER TIGHTENING SPECIFICATIONS
| ITEM | SPECIFICATION | |
|---|---|---|
| Transaxle | Control cable bracket | 23 ± 3 N.m (17 ± 2 ft-lb) |
| Eye bolt | 24 ± 3 N.m (18 ± 2 ft-lb) | |
| Fluid temperature sensor | 11 ± 1 N.m (95 ± 9 in-lb) | |
| Input shaft speed sensor | 11 ± 1 N.m (95 ± 9 in-lb) | |
| Manual control lever | 22 ± 3 N.m (16 ± 2 ft-lb) | |
| Manual control shaft detent | 6.0 ± 1.0 N.m (52 ± 9 in-lb) | |
| Oil pump | 29 ± 2 N.m (21 ± 1 ft-lb) | |
| Output shaft bearing retainer <F4A42> | 29 ± 2 N.m (21 ± 1 ft-lb) | |
| Output shaft bearing retainer <F4A51> | 54 ± 5 N.m (40 ± 4 ft-lb) | |
| Output shaft jam nut | 167 ± 10 N.m (123 ± 7 ft-lb) | |
| Output shaft speed sensor | 11 ± 1 N.m (95 ± 9 in-lb) | |
| Park/neutral position switch (PNP switch) | 11 ± 1 N.m (95 ± 9 in-lb) | |
| Rear cover | 23 ± 3 N.m (17 ± 2 ft-lb) | |
| Roll stopper bracket | 69 ± 10 N.m (51 ± 7 ft-lb) | |
| Sealing cap | 5.0 ± 1.0 N.m (43 ± 9 in-lb) | |
| Torque converter housing | 48 ± 6 N.m (35 ± 4 ft-lb) | |
| Transfer drive gear | 34 ± 2 N.m (25 ± 1 ft-lb) | |
| Valve body cover | 11 ± 1 N.m (95 ± 9 in-lb) | |
| Valve body mounting bolt | 11 ± 1 N.m (95 ± 9 in-lb) | |
| Wiring harness bracket | 23 ± 3 N.m (17 ± 2 ft-lb) | |
| Components | Differential drive gear | 135 ± 5 N.m (100 ± 3 ft-lb) |
| Plate | 6.0 ± 1.0 N.m (52 ± 9 in-lb) | |
| Solenoid valve support | 6.0 ± 1.0 N.m (52 ± 9 in-lb) | |
| Valve body | 11 ± 1 N.m (95 ± 9 in-lb) | |