Component Testing: Brush

WARNING: This page is about a different car, the 2004 Mitsubishi Eclipse. However, it is still accessible from the selected car via links, so may be relevant.

Replace the brush is the brush protrusion length is below 0.08" (2 mm). See Fig 1 .
The brush can be removed by unsoldering the brush lead wire. See Fig 2 .
When installing a new brush, push the brush in to the brush holder, and solder the lead wire.

Fig 1: Identifying Protrusion Length

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Locating Soldered Wires

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.