Inspection Procedure 2: Accelerator Pedal Operation Is Not Smooth (Over Acceleration): Diagnosis

WARNING: This page is about a different variant/trim than selected.

STEP 1. Check the accelerator pedal.
Q: Is the accelerator pedal loose?
1. YES: Tighten, then go to Step 4 .
2. NO: Go to Step 2.
STEP 2. Check the accelerator cable wiring.
Q: Is the accelerator cable routing bent sharply?
1. YES: Repair, then go to Step 4 .
2. NO: Go to Step 3.
STEP 3. Check the accelerator cable lubricant.
Q: Is the accelerator cable lubricated sufficiently?
1. YES: There is no action to be taken.
2. NO: Refill or replace the lubricant, then go to Step 4.
STEP 4. Retest the system.
Q: Does the accelerator pedal work normally?
1. YES: The procedure is complete.
2. NO: Return to Step 1 .