LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2004 >> Lancer Evolution >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 48 (Power Steering - Except Evolution & SPORTBACK) >> Steering Wheel And Shaft Assembly >> Removal And Installation >> Removal Service Points >> << B >> Steering Wheel And Airbag Module Assembly Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

<< B >> Steering Wheel And Airbag Module Assembly Removal

WARNING: This page is about a different variant/trim than selected.
  1. BY sliding section A of the clock spring connector shown in the illustration in the arrow direction, disconnect the connector.
    Fig 1: Positioning Clock Spring Connector
    G00955199Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Loosen the bolt completely. Then, remove the steering wheel and airbag module assembly.
    NOTE: Use a hexagonal bit socket or a hexagonal wrench having an effective length of 75 mm (3.0 inches) or more in the hexagonal section and the diameter of 8 mm (0.31 inches) or more.
    Fig 2: Identifying Hexagonal Bit Socket
    G00955200Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals