LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2004 >> Lancer Evolution >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxle Overhaul - Evolution >> Output Shaft >> Disassembly And Assembly >> Assembly Service Points >> >> E << 1ST-2ND Speed Synchronizer Hub Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

>> E << 1ST-2ND Speed Synchronizer Hub Installation

  1. Set the output shaft on the press support stand.
  2. Check that the 1st-2nd speed synchronizer hub is in the correct installation direction, and put it on the output shaft.
    Fig 1: Installing Speed Synchronizer Hub Installation
    G00977744Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Using special tools MD998812, MD998814 MD998824 and MD998364, press install the 1st-2nd speed synchronizer hub with the press.
  4. Make sure that the outer synchronizer ring on the 1st speed gear side can rotate freely.
    Fig 2: Using Special Tools Md998812,814,824 And Md998364
    G00977745Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals