Past trouble
- Carry out diagnosis with particular emphasis on connector(s) or wiring harness in the CAN bus lines between the powertrain control module and the combination meter, and the power supply system to the powertrain control module. For diagnosis procedures, Refer to " HOW TO TREAT PAST TROUBLE " (Refer to HOW TO USE TROUBLESHOOTING/INSPECTION SERVICE POINTS ).
NOTE:
For a past trouble, you may not find it by the MUT-III CAN bus diagnostics even if there is any failure in CAN bus lines. In this case, Refer to
HOW TO USE TROUBLESHOOTING/INSPECTION SERVICE POINTS
.) and check the CAN bus lines. You can narrow down the possible cause of the trouble by referring to the DTC, which is set regarding the CAN communication-linked ECUs (Refer to PRECAUTIONS ON HOW TO REPAIR THE CAN BUS LINE
).