Overhaul -- Evolution MR
- General Description
- Special Tools
- Transaxle (Transmission)
- Disassembly And Assembly
- Notes
- Disassembly Service Points
- Assembly Service Points
- << A >> Input Shaft Assembly / Main Shaft Assembly / Reverse Idler Gear Assembly Installation
- >> B << 1ST-2ND Fork Rod / 1ST-2ND Shift Fork Installation
- >> C << Shift Check Sleeve Installation
- >> D << 3RD-4TH Bracket / 3RD-4TH Shift
- >> E << Interlock Ball Installation
- >> F << 5TH-6TH Bracket / 5TH-6TH Shift Fork
- >> G << Interlock Ball Installation
- >> H << Reverse Bracket Fork Rod / Reverse Bracket Installation
- >> I << Reverse Lever Assembly Installation
- >> J << Shift Check Sleeve / Check Ball / Check Spring / Check Ball Plug Installation
- >> K << Differential Side Bearing Adjustment Shim Installation
- >> L << Differential Side Bearing Outer Race Installation
- >> M << Adjustment Shim Installation (Input Shaft Rear Bearing / Main Shaft Rear Bearing / Reverse Idler Gear)
- >> N << Transaxle Case Installation
- >> O << Control Assembly Installation
- >> P << Reverse Switch Installation
- Transaxle (Transmission) Inspection
- Disassembly And Assembly
- Input Shaft
- Disassembly And Assembly
- Notes
- Disassembly Service Points
- << A >> Input Shaft Rear Bearing Removal
- << B >> 6TH Gear Sleeve / Needle Bearing / 6TH Gear Removal
- << C >> 5TH-6TH Synchronizer Assembly / Synchronizer Ring / 5TH Gear Removal
- << D >> 5TH Gear Sleeve / Thrust Washer / 4TH Gear / Needle Bearing / 4TH Gear Sleeve / 3RD-4TH Synchronizer Assembly / Synchronizer Outer Ring / Synchronizer Cone / Synchronizer Inner Ring / 3RD Gear Removal
- << E >> Ball Bearing Removal
- Assembly Service Points
- >> A << Ball Bearing Installation
- >> B << 3RD-4TH Synchronizer Hub / Synchronizer Key / Synchronizer Sleeve
- >> C << 3RD-4TH Synchronizer Assembly Installation
- >> D << 4TH Gear Sleeve Installation
- >> E << Thrust Washer Installation
- >> F << 5TH Gear Sleeve Installation
- >> G << 5TH-6TH Synchronizer Hub / Synchronizer Keys / Synchronizer
- >> H << 5TH-6TH Synchronizer Assembly Installation
- >> I << 6TH Gear Sleeve Installation
- >> J << Snap Ring Installation
- >> K << Input Shaft Rear Bearing Installation
- Input Shaft Inspection
- Disassembly And Assembly
- Reverse Idler Gear
- Clutch Housing
- Transmission Case
- Center Differential
- Disassembly And Assembly
- Notes
- Disassembly Service Points
- Assembly Service Points
- >> A << Taper Roller Bearing Installation
- >> B << Spacer / Side Gear / Washer / Pinion / Pinion Shaft Holder / Pinion Shaft / Lock Pin / Front Output Shaft / Snap Ring / Center Differential Flange Installation
- >> C << Taper Roller Bearing Installation
- >> D << Center Differential Drive Gear Installation
- Disassembly And Assembly
- Transfer
- Specifications