LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2005 >> Lancer Evolution >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (General -- Except Evolution) >> Precautions Before Service >> Learning Procedure For Idling In MFI Engine >> Learning Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Learning Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Start the engine and carry out the warm-up for the engine coolant temperature to reach 80°C or more.
  2. When the engine coolant temperature is 80°C or more, the warm-up is not needed if the ignition switch is in "ON" position once.
  3. Place the ignition switch in "LOCK" (OFF) position and stop the engine.
  4. After 10 seconds or more, start the engine again.
  5. For 10 minutes, carry out the idling under the condition shown below and then confirm the engine has the normal idling.
    • Transaxle: "P" range
    • Operation in ignition-related, fan and attachments: Not to be operated
    • Engine coolant temperature: 80°C or more
      NOTE: When the engine stalls during the idling, check the dirtiness (on the throttle valve) of the throttle body and then perform the service from Procedure 1 again.
scientia non olet · About LEMON Manuals