Installation Service Point
WARNING: This page is about a different car, the 2006 Mitsubishi Montero. However, it is still accessible from the selected car via links, so may be relevant.
>>A<< G AND YAW RATE SENSOR INITIALIZATION
If the G and yaw rate sensor is replaced, park the vehicle on a level surface and follow the procedure below.
- Connect scan tool MB991958 to the data link connector.
- Turn the ignition switch to the "ON" position.
- Execute item No. 16 "G SNSR:" on the Actuator test.
- Turn the ignition switch to the "LOCK" (OFF) position.
- Disconnect scan tool MB991958.