INSPECTION PROCEDURE 2: Accelerator Pedal Operation not Smooth (Over Acceleration): Diagnosis
- STEP 1. Check the accelerator pedal.
Q: Is the accelerator pedal good condition?
YES: Go to Step 2.
NO: Replace the accelerator pedal (Refer to ACCELERATOR CABLE AND PEDAL ). Then go to Step 5.
- STEP 2. Check the installation condition of the accelerator pedal.
Q: Is the accelerator pedal loose?
YES: Tighten, then go to Step 5.
NO: Go to Step 3.
- STEP 3. Check the accelerator cable wiring.
Q: Is the accelerator cable routing bent sharply?
YES: Repair, then go to Step 5.
NO: Go to Step 4.
- STEP 4. Check the accelerator cable lubricant.
Q: Is the accelerator cable lubricated sufficiently?
YES: Go to Step 5.
NO: Refill or replace the lubricant, then go to Step 5.
- STEP 5. Retest the system.
Q: Does the accelerator pedal work normally?
YES: The procedure is complete.
NO: Return to Step 1.