- Insert the ignition key into the key cylinder and check that the doors have been locked normally when the ignition key is turned.
- Insert the ignition key into the key cylinder.
CAUTION:
Turn the ignition switch to the "LOCK" (OFF) position and then connect data link connector terminal 1 to ground.
- Connect the data link connector terminal 1 to ground.
NOTE:
Connecting terminal 1 of the data link connector to ground will put the system in secret code registration standby mode.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
- Push the hazard warning light switch six times within 10 seconds.
NOTE:
At this time the code registration monitor request is output and becomes registration mode (all doors locked and then all doors unlocked).
NOTE:
The hazard warning light switch is turned on and off alternately whenever it is pushed.
- Press the transmitter button, and then press it two times within 10 seconds of the first press. This will register the code.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
- When registration is completed, the code registration monitor request is output (all doors locked and then all doors unlocked).
- If you are using two or more transmitters or have added a second transmitter, the next transmitter should be registered within one minute after registering the code for the previous transmitter. The registration procedure is common for all the transmitter.
- Registration mode will be canceled under the following conditions:
- When the secret code for four transmitters has been registered;
- When passing one minute after finishing the registration of all transmitters;
- When no secret codes have been registered for more than one minute after the registration mode is entered;
- When the data link connector terminal 1 to ground is disconnected;
- When the ignition key is removed from the ignition key cylinder;
- After the registration is completed, carry out the following.
CAUTION:
Turn the ignition switch to the "LOCK" (OFF) position and then disconnect data link connector terminal 1 from ground.
- Disconnect data link connector terminal 1 from ground.
- Remove the ignition key from ignition key cylinder.
- Close all of the doors.
- Verify the keyless entry system operates normally.