Service Specifications
SERVICE SPECIFICATIONS
| ITEM | STANDARD VALUE | MINIMUM LIMIT |
|---|---|---|
| Input shaft end play mm (in) | 0.05 - 0.17 (0.0020 - 0.0067) | - |
| Input shaft front bearing end play mm (in) | 0 - 0.12 (0 - 0.0047) | - |
| Input shaft rear bearing end play mm (in) | 0 - 0.12 (0 - 0.0047) | - |
| Input shaft 5th speed gear end play mm (in) | 0 - 0.09 (0 - 0.0035) | - |
| Output shaft preload mm (in) | 0.13 - 0.18 (0.0051 - 0.0071) | - |
| Output shaft taper roller bearing end play mm (in) | 0 - 0.09 (0 - 0.0035) | - |
| Output shaft 3rd speed gear end play mm (in) | 0 - 0.09 (0 - 0.0035) | - |
| Center differential pinion backlash mm (in) | 0.025 - 0.150 (0.0010 - 0.0059) | - |
| Center differential case preload mm (in) | 0.05 - 0.11 (0.0020 - 0.0043) | - |
| Synchronizer ring back surface to gear clearance mm (in) | - | 0.5 (0.020) |