Fastener Tightening Specifications
WARNING: This page is about a different car, the 2005 Mitsubishi Montero. However, it is still accessible from the selected car via links, so may be relevant.
FASTENER TIGHTENING SPECIFICATIONS
| ITEM | SPECIFICATION |
|---|---|
| Brake line | |
| Brake tube flare nut | 15 ± 2 N.m (11 ± 2 ft-lb) |
| Brake pedal | |
| Hydraulic brake booster mounting nut | 14 ± 3 N.m (124 ± 26 in-lb) |
| Pedal support member mounting bolt | 12 ± 2 N.m (107 ± 17 in-lb) |
| Buzzer | |
| Buzzer mounting nut | 5.0 ± 1.0 N.m (44 ± 9 in-lb) |
| Hydraulic brake booster (HBB) | |
| Accumulator | 54 ± 5 N.m (40 ± 4 ft-lb) |
| Brake tube flare nut (between master cylinder and pump motor) | 15.2 ± 3 N.m (11 ± 2 ft-lb) |
| Clevis nut | 25.5 ± 5.1 N.m (19 ± 3 ft-lb) |
| Hydraulic brake booster mounting nut | 14 ± 3 N.m (124 ± 26 in-lb) |
| Lead wire screw (hydraulic unit side) | 1.7 ± 0.1 N.m (15 ± 1 in-lb) |
| Lead wire screw (pump motor side) | 3.0 ± 0.5 N.m (26 ± 4 in-lb) |
| Pump motor bracket mounting bolt | 11.8 ± 2.3 N.m (104 ± 20 in-lb) |
| Pump motor mounting bolt | 7.8 ± 1.5 N.m (69 ± 13 in-lb) |
| Reservoir assembly mounting screw | 1.7 ± 0.3 N.m (15 ± 2.6 in-lb) |
| Front disc brake | |
| Bleeder screw | 7.4 ± 1.4 N.m (65 ± 13 in-lb) |
| Brake hose connector bolt | 30 ± 4 N.m (22 ± 3 ft-lb) |
| Front brake assembly mounting bolt | 113 ± 9 N.m (83 ± 7 ft-lb) |
| Guide pin | 89 ± 4 N.m (66 ± 3 ft-lb) |
| Guide pin lock bolt | 89 ± 4 N.m (66 ± 3 ft-lb) |
| Rear disc brake | |
| Bleeder screw | 7.9 ± 0.9 N.m (70 ± 8 in-lb) |
| Brake hose connector bolt | 30 ± 4 N.m (22 ± 3 ft-lb) |
| Rear disc brake assembly mounting bolt | 100 ± 10 N.m (74 ± 7 ft-lb) |
| Guide pin | 44 ± 5 N.m (33 ± 3 ft-lb) |
| Lock pin | 44 ± 5 N.m (33 ± 3 ft-lb) |