DTC U0168: Lost Communication With Vehicle Security Control Module (SKREEM/WCM): Notes

Fig 1: Communication Circuit Diagram

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

For a complete wiring diagram Refer to SYSTEM WIRING DIAGRAMS .

• When Monitored: 
  • With the ignition on 
  • Battery voltage between 10 and 16 volts 
  • IOD fuse installed 
  • FCM is configured correctly 
• Set Condition: 

  Bus messages not received from the Sentry Key Remote Entry Module (WCM) for approximately 2 to 5 seconds  .

Possible Causes 

CAN B BUS CIRCUITS OPEN OR SHORTED

DTCS RELATED TO BATTERY VOLTAGE, IGNITION, OR VIN MESSAGES

FCM NOT CONFIGURED CORRECTLY

SENTRY KEY REMOTE ENTRY MODULE POWER AND GROUND

SENTRY KEY REMOTE ENTRY MODULE

MODULE THAT SET THIS DTC