Headlight Adjustment

NOTE: When adjusting headlight, disconnect the other headlight harness.

The low beam headlight will project on the screen upper edge of the beam (cut-off).
Turn the adjusting screws to achieve the specified low-beam cut-off location on the aiming screen.

Fig 1: Adjusting Headlight (Vertical)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Adjusting Headlight (Horizontal)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Standard value:

(Vertical direction) Horizontal line (H) ± 50.5 mm (± 2.0 inches) (0.38 degrees angle)

(Horizontal direction) : ± 126.4 mm (± 5.0 inches) (± 0.95 degrees angle) from the axis, which is 266.1 mm (10.5 inches) (2 degrees angle) rightward from the vertical line (V)

Fig 3: Identifying Headlight Adjusting Dimension
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

CAUTION: Do not cover a headlight for more than three minutes to prevent the plastic headlight lens deformation.

NOTE: High-beam pattern should be correct when the low-beams are adjusted properly.