How To Perform Actuator Test
Required Special Tools:
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: V.C.I.
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A
CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
- Connect scan tool MB991958 to the data link connector.
- Turn the ignition switch to the "ON" position.
- Select the "Interactive Diagnosis" from the start-up screen.
- Select the "System Select."
- Choose the "TCL" from the "POWERTRAIN" tab.
- Choose the "Actuator Test" from the "TCL" screen.
- Choose an appropriate item.
- Turn the ignition switch to the "LOCK" (OFF) position.
- Disconnect scan tool MB991958.