LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2007 >> Lancer Automatic >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2007 GALANT 2.4L, Outlander >> Pattern 10 >> Test Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Drive the vehicle for 20 minutes at the following conditions. (During the monitor)
    • Vehicle speed: More than 50 km/h (32 mph)
    • Except fuel cut The system is normal if engine coolant temperature will rise more than 82°C (180°F) within 20 minutes.
  3. Stop at safe place and turn the ignition switch to "LOCK" (OFF) position.

Start the engine and do Steps 1 to 3 again. Confirm that the diagnostic trouble code (DTC) is not output.

scientia non olet · About LEMON Manuals