LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2007 >> Lancer Standard >> Repair and Diagnosis (Single Page) >> Electrical >> Charging Systems >> Charging System - Lancer >> On-Vehicle Service >> Wave Pattern Check Using An Oscilloscope >> Standard Waveform >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Standard Waveform: Notes

STANDARD WAVEFORM

Observation Conditions
FUNCTION SPECIAL PATTERNS
Pattern height Variable
Variable knob Adjust while viewing the wave pattern
Pattern selector Raster
Engine revolutions Curb idle speed
Fig 1: Voltage Wave Form Graph
G04271507Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
NOTE: The voltage waveform of the generator "B" terminal can undulate as shown at left. This waveform is produced when the regulator operates according to fluctuations in the generator load (current), and is normal for the generator.

If the ripple height is abnormally high (approximately 2 V or more during idling), the wires between the generator "B" terminal and the battery have broken due to fuse blowing, etc. The generator is usually operating properly.

Fig 2: Voltage Wave Form Graph
G04271508Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.