>>A<< Steering Column Shaft Assembly Installation

< When re-using steering column shaft assembly >

CAUTION: Do not release the tilt lever until the steering column shaft assembly has been installed.

Ensure that the tilt lever is in the lock position, and install the steering column shaft assembly. Tighten the four bolts in the order shown by hand, and then tighten them to the specified torque in the order shown.

Tightening torque: 12 +/- 2 N.m (102 +/- 22 in-lb)

Fig 1: Installing Tilt Lever Lock Position (1 Of 3)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

< When replacing steering column shaft assembly (Replacement tilt lever with fixing band) >

CAUTION:

Do not release the tilt lever until the steering column shaft assembly has been installed.
Remove the fixing band after the installation has been done.

Tightening torque: 12 +/- 2 N.m (102 +/- 22 in-lb)

< When replacing steering column shaft assembly (Replacement tilt lever without fixing band) >

CAUTION: Do not release the tilt lever until the steering column shaft assembly has been installed.

Tightening torque: 12 +/- 2 N.m (102 +/- 22 in-lb)

Fig 2: Installing Tilt Lever Lock Position (2 Of 3)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Installing Tilt Lever Lock Position (3 Of 3)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.