Removal And Installation: Notes

WARNING: This page is about a different car, the 2005 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: *: Indicates parts which should be temporarily tightened, and then fully tightened after installing the engine into the vehicle.

Fig 1: Removal Steps Of Transaxle Assembly (1 Of 2)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Removal Steps Of Transaxle Assembly (2 Of 2)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

MB990767: End Yoke Holder
MB991897: Ball Joint Remover
MB990241: Axle Shaft Puller
MB990242: Puller Shaft PUller
MB990244: Puller Bar
MB991354: Puller Body
MB991017: Front Hub Remover and Installer
MB991000: Spacer
MB991460: Plug
MB991527: Hanger
MB991454: Engine Hanger Balancer (chain)
MB991895: Engine Hanger
MB991928: Engine Hanger
MB991932: Foot (standard)
MB991933: Foot (short)
MB991930: Joint (90)
MB991931: Joint (140)