LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2007 >> Outlander ES >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Wireless Control Module (WCM) >> Diagnosis >> Id Codes Registration Judgment Table >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Id Codes Registration Judgment Table: Notes

CAUTION: Do not replace the engine control module (ECM) and WCM at the same time. When replacing several ECUs, always replace one ECU at a time, register the necessary IDs in it, and then replace the next ECU.

The transponder (a small transmitter) in the ignition key, WCM, and the ECM have their own ID codes stored in them. When the cases listed in the table below occur, the ID codes must be registered in the WCM or ECM again.

NOTE: Up to eight ignition keys (key ID and keyless entry secret code) can be stored in the memory of WCM.
ID CODES REGISTRATION JUDGMENT TABLE

Item Operation contents and procedure Reference page for registration contents
When the ECM is replaced Registration of Key codes Key code registration (Refer to HOW TO PERFORM VIN WRITING .)
When WCM is replaced
  1. VIN programmed
  2. Register all the ignition keys again.
  3. Register the keyless entry secret code for all the ignition keys again (keys with transmitters only).
  4. Register the TPMS transmitters
When the ignition key is added as a single unit
  1. Register all the ignition keys again.
  2. Register the keyless entry secret code for all the ignition keys again (keys with transmitters only).
 Key Registration and Keyless ID Registration (Refer to ID CODES REGISTRATION PROCEDURE  )
When the ignition key is lost as a single unit
  1. Register all the ignition keys other than the lost one again.
  2. Register the keyless entry secret code for all ignition key other than the lost ignition key again
When the ignition key is replaced by the full service key set or the handle lock service key set is replaced by the piece.
  1. Register all ignition keys again input barcode No.
  2. Register the keyless entry secret code for all the ignition keys again (set supply only).
 Key Registration (Barcode No.) and Keyless ID Registration (Refer to ID CODES REGISTRATION PROCEDURE  )
When the blank key(1) is replaced by the door service key set or glove box service key set is added by the piece. Operation is not needed -
When TPMS transmitter is replaced Register the TPMS transmitter Registering tire pressure sensor ID. (Refer to TIRE PRESSURE SENSOR ID REGISTRATION  .)
(1) Blank key (the key that can be used to lock/unlock the door, back door or glove box only)
SUPPLY UNIT LIST FOR INDIVIDUAL KEY

Ignition key (with transmitter)
NOTE: Blank key (It is the key that comes with the door service key set and the glove box service key set. It can only be used for locking and unlocking, and it cannot start the engine.)
G04872563
G04872412
KEY SUPPLY UNIT LIST FOR OTHER THAN INDIVIDUAL KEY

Full service key set Handle lock service key set Door service key set Glove box service key set
G04872565
G04872566
G04872416
G04872417
scientia non olet · About LEMON Manuals