LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2007 >> Outlander ES >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Diagnosis & On-Vehicle Testing >> On-Vehicle Service >> Automatic Transaxle Control Component Check >> A/T Control Relay Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

A/T Control Relay Check

  1. Remove the A/T control relay.
    Fig 1: Identifying A/T Control Relay
    G04871141Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Checking Continuity Between A/T Control Relay Terminals No 3 And No 4
    G04871142Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Use jumper wires to connect A/T control relay terminal No.1 to the negative battery terminal and terminal No.2 to the positive battery terminal.
  3. Check for continuity between A/T control relay terminals No.3 and No.4 when the jumper wires are connected to and disconnected from the battery.
    CONTINUITY REFERENCE CHART

    Jumper wire Continuity between terminals No.3 and No.4
    Connected Continuity exists (2Ω or less)
    Disconnected No continuity
  4. If there is any problem with the A/T control relay, replace it.
scientia non olet · About LEMON Manuals