Tire Pressure Sensor Id Check: Notes
Required Special Tools:
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A
Check the tire pressure sensor IDs, which is registered in the TPMS receiver, as described below.
CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
- Connect scan tool MB991958 to the data link connector.
- Turn the ignition switch to the "ON" position.
- Select "Interactive Diagnosis" from the start-up screen.
- Select "System select."
- Choose "TPMS" from the "CHASSIS" tab.
- Select "MITSUBISHI."
- Select "Special Function."
- Select "Tire Pressure Sensor ID Check."
- Check the tire pressure sensor IDs on the PC display.
- After tire pressure sensor ID check, turn the ignition switch to the "LOCK" (OFF) position.
- Remove scan tool MB991958.